#Laying concrete blocks without mortar skin#

Because of some irregularities in the blocks, it may be necessary periodically to insert shims (or even a little mortar) under the blocks to keep them level. After that, the walls go up in rapid order as the blocks are stacked dry. This is done simply to start with a level first course on the usually irregular poured-concrete base. In surface-bonding, the first course of blocks is often laid in a bed of mortar. As Fred Kennedy put it: ''Who cannot stack one block on top of another?'' Many do-it-yourselfers who would not tackle conventional block-wall construction have the confidence to go the surface-bonding route. But for the average home handyman, the simplicity of the method, more than its speed, is the important factor. Reinforcing rods are placed through the hollow cores of the outer thickness, which are then filled with concrete.Ī skilled mason's productivity has been found to increase 70 percent when using the surface-bonding approach to building. These pilasters are tied into the wall by laying alternate courses crosswise. On long walls, it is recommended that concrete pilasters (a double thickness of the blocks) be built in at intervals roughly 18 times the width of the wall. Commercial buildings have been constructed as high as 14 feet in this manner.Īnother advantage of surface bonding: It makes the wall highly waterproof. This is why current recomendations from the National Concrete Masonry Association limit the height of a surface-bonded building to two stories. On the other hand, it is not so effective at withstanding vertical pressure. The surface-bonded wall, in fact, can resist lateral pressure several times more effectively than a mortar-laid wall.

#Laying concrete blocks without mortar skin#

The compound dries to form a skin of remarkable strength which holds the blocks together more effectively than conventional mortar. After the wall is up, the bonding is done by troweling a layer of the bonding compound - a cement and fiber-glass mix - over both sides of the wall. They are stacked dry, much the way a child stacks toy building blocks. In other words, no mortar is used to hold the blocks together. Surface bonding, according to the University of Georgia College of Agriculture (which began developing the concept in 1967), is ''both a material and a technique'' for erecting concrete-block walls without the use of mortar. What he found is a much simpler and much faster way to go for the would-be builder with little or no experience in laying bricks or concrete blocks.

Then someone suggested he look into surface bonding. If he were to build the cellar walls of cement block, he would have to acquire some basic bricklaying skills in a hurry. That omission became significant only when he made plans to build his own home here in this rural Maine community. During many years of varying work experiences, Fred Kennedy used just about every hand tool devised by man with one exception - the mason's trowel.